Vega Systems Inc - RMF Docs
  • Introduction
  • Release Notes
    • 7.1.6
    • 7.1.5
    • 7.1.4
    • 7.1.3
    • 7.1.2
    • 7.1.0
  • Key Features
  • Software Components
  • What to Install Where
    • Single Site
      • Non-Clustered Mode
      • Clustered Mode
    • Federated
      • Non-Clustered Mode
      • Clustered Mode
    • Independent
      • Non-Clustered Mode
      • Clustered Mode
  • Installation
    • Pre-Installation
    • Manual Installation
      • RMF Services (Manual)
      • RMF Client (Manual)
    • Silent Installation
      • RMF Services (Silent)
      • RMF Client (Silent)
    • Post-Installation
      • Validate the Installation of RMF Services and UI
      • Validate the Installation of RMF Smart Client Components
    • Uninstallation
      • Manual Uninstallation
      • Silent Uninstallation
  • License Activation
    • Online Activation
    • Offline Activation
      • Export License for Activation
      • Import Activated License
  • Configuration Dashboard
    • Accessing the RMF Config Dashboard
    • Enable the SmartSync Service
      • Smart Sync Service Service Tray
        • Set Service Logon Settings
        • Start
        • Stop
        • Restart
        • Restart with detailed logs
        • Show Log
        • Clear Log
        • Exit
    • Set Synchronization Direction
      • Backup Mode
      • Restore Mode
    • Architecture Selection
      • Single Site
      • Federated
      • Independent
    • Server Labeling
    • Mode Selection
    • Server Linking
    • Storage Linking
    • Licensing
    • Add Camera
    • First Synchronization Run
    • Replace Camera
    • Move Camera
    • Delete Camera
    • Device Selection
    • Synchronize Hardware
    • Synchronize Camera
    • Synchronize Microphone
    • Synchronize Speaker
    • Synchronize Device Input
    • Synchronize Device Output
    • Synchronize Metadata
    • Synchronize Groups
    • Synchronize Roles
    • Synchronize Views
    • Scheduling Runs
      • Enable the SmartSync Scheduling
      • Disable the SmartSync Scheduling
  • Run/Process Dashboard
    • Accessing the Dashboard
    • Run/Process Dashboard Details
Powered by GitBook
On this page
  • About
  • Scope
  • Enable
Export as PDF
  1. Configuration Dashboard

Synchronize Hardware

Precision Synchronization for Hardware Settings

PreviousDevice SelectionNextSynchronize Camera

Last updated 2 months ago

About

Each hardware device could contain one or more cameras, speakers, microphones, inputs, outputs, and metadata streams. Use this block to control which hardware properties are automatically synchronized by RMF. Such settings correspond to IP addresses, passwords, device-level event definitions, hardware names, etc.

Scope

The scope of action is limited to RMF-licensed devices selected in the Device Selection section. The direction of synchronization depends on the direction setting. See Set Synchronization Direction. If no devices are selected in the Device Selection block, this option is disabled.

Please see the "Settings here correspond to" section in the picture below to understand which XProtect features this screen synchronizes.

Enable

To synchronize your hardware settings, follow these steps:

  1. Click Hardware.

Note: The hardware block will only be clickable if at least one device is selected from the Devices section. For more information, refer to Device Selection documentation.

  1. Enable the Overall Hardware Settings Sync to synchronize all the individual hardware settings. Different sub-settings can be enabled or turned off as needed.

  1. To retain your configured settings, click the 'Check Mark' icon. Then, click 'Save' in the Milestone toolbar to save changes.

Hardware Settings Screen
Hardware Option
Synchronize the Required Hardware
Save Icon—Milestone Toolbar